Issue
Your Centauri Carbon 2 3D printer shows a message "ErrorCode 801" after startup.
Cause
The Extruder Communication Cable may need to be re-seated or replaced.
How to Fix
Turn the printer off.
Undo the screws on top of the print head, pull the cable out vertically, re-seat it and screw it down.
Turn the printer on again, see if this error message has gone.
If the error is still there, turn the printer off, tip it on it's left, and remove the screws in the bottom plate.
Locate the black Molex plug next to the screen ribbon cable, press the clip and remove/re-seat the plug.
Re-attach the bottom plate. Tip the printer upright, turn it on, and see if the error message has gone.
If the error message is still there, the most likely cause is a failed cable; a replacement cable is available as 002022 and the replacement process is here.
Otherwise, test the mainboard (002018) or Extruder Communication PCB (002010) as shown here.
Comments
0 comments
Article is closed for comments.